Picture of STARboost Voltage Booster for Starlink Mini, 12/24 V to 30 V, Ring Terminals
STARboost Voltage Booster for Starlink Mini, 12/24 V to 30 V, Ring Terminals
  • $44.99
  • In Stock
  • SKU: STARboost-HW

STARboost Voltage Booster for Starlink Mini, 12/24 V to 30 V, Ring Terminals

Hardwires a Starlink Mini into a 12 V or 24 V system: two 5/16 in heat shrink ring terminals with an inline 10 A fuse bolt to a battery, bus bar or fuse block, and the booster holds 30 V at up to 3 A. A 116 in cable runs to a 5.5 x 2.1 mm plug. Read Full Description
$44.99
Availability: In Stock
SKU: STARboost-HW

The STARboost is a DC voltage booster for the Starlink Mini. It takes 10 to 28 V DC from a 12 V or 24 V battery or vehicle system and holds a regulated 30 V at up to 3 A on a 5.5 x 2.1 mm plug for the Mini's DC input. This version hardwires to a battery, bus bar or fuse block with two 5/16 in ring terminals and an inline 10 A fuse.

30 V Regulated output
90 W 3 A maximum
10 to 28 V DC input

Which STARboost?

ModelInput connectorInline fuseConnects to
STARboost, Cigarette PlugCigarette lighter plug10 A, in the plug12 V or 24 V accessory socket
STARboost, PowerpoleAnderson Powerpole PP15-4510 A, positive leadPowerpole boxes and distribution blocks
STARboost, Ring TerminalsTwo 5/16 in ring terminals10 A, positive leadBattery, bus bar or fuse block studs

The STARboost, Ring Terminals on this page is the one for a permanent install in a van, RV, boat or truck. Only the input end differs.

Key specifications

Input voltage10 to 28 V DC, for 12 V and 24 V systems
Output30 V DC regulated, up to 3 A (90 W)
Input connectorTwo heat shrink ring terminals, 5/16 in (8 mm) stud
Input fuse10 A mini fuse, inline on the positive lead
Input lead12 in (305 mm)
Output plug5.5 x 2.1 mm DC coaxial plug
Output cable116 in (2.95 m)
Wire16 AWG
ProtectionOvercurrent, short circuit, over-temperature
EnclosurePotted and sealed, not rated for submersion
SizeAbout 3 x 3 x 1 in (76 x 76 x 25 mm)

Why boost to 30 V?

The Starlink Mini reboots when its 12 V supply sags: a battery under load, a long or thin cable, a dip while the vehicle charges. The STARboost holds 30 V across its whole input range, whatever the battery does. At 30 V the same power takes 40% of the current it needs at 12 V, so the cable loses less.

Connecting it

Bolt the positive terminal to a positive 5/16 in stud and the negative to ground, on a battery, bus bar or fuse block. The 10 A fuse sits in the positive lead; replace it only with another 10 A mini fuse.

Common questions

Does it work with the Starlink Mini 2?

No. The Mini 2 takes power over USB-C, not a DC barrel plug, so this plug does not fit it; use a USB-C PD source of 60 W or more.

Will it drain my battery?

It draws whenever the Mini is on; to protect a starting battery, add a DC timer or low-voltage disconnect.

Customer Reviews

Write a review of this product and share your opinion with others.
Not Good Needs That Special Something Average, Ordinary That's Good Stuff Perfect. It doesn't get any better
The most useful comments contain specific examples about:
  • How you use the product
  • Things that are great about it
  • Things that aren't so great about it